Notifier AFP-3030 Installation Manual

Also see for AFP-3030: Programming manual Operation manual Operation manual Installation manual

Contents

Notifier AFP-3030 Installation Manual Manual pdf 32 page image

27 AFP-3030 Installation Manual — P/N DOC-01-037:B 25/08/2016Installation Wiring a Signalling Line Circuit (SLC)3.11.2 Configuring the PrinterRefer to the documentation supplied with the printer for configuration instructions.PRN Printer SettingsSet the printer options (under the menu area) according to the settings listed in Table 3.3.3.12 Wiring a Signalling Line Circuit (SLC)3.12.1 SLC OverviewCommunication between the CPU and intelligent and addressable initiating, monitor, and controldevices takes place through a Signalling Line Circuit (SLC). This manual provides requirementsand performance details specific to this control panel; for installation information and generalinformation, refer to the SLC Wiring Manual.For electrical specifications, see Appendix A.2 “SLC Loops”. For additional notes on SLCresistance values, see Section 4.1 “Operational Checks”.3.12.2 SLC CapacityThe AFP-3030 supports up to five pairs of LCM-320 and LEM-320 modules, providing from oneto ten SLC loops. Loop capacity depends on operating mode:• Flash Scan: 01-159 intelligent detectors, 01-159 monitor and control modules• CLIP: 01-99 intelligent detectors, 01-99 monitor and control modulesFlashScan devices can operate in either FlashScan or CLIP mode. Older models of CLIP devicesonly support addresses up to address 99. CLIP loops are limited to 99 detectors and 99 modules.The following configuration guidelines may be used to improve the response times of CLIP loops:1. All manual pull stations must be assigned addresses from 1-20.*Protocol: When printing in graphics mode, set I/O Serial Protocol to “Robust XON/OFF”.Option SettingL/R Adjust 0Font HS DraftCPI 10 CPILPI 6 LPISkip 0.0ESC Character ESCEmulate FX-850Bidirectional Copy ONI/OInterfaceBufferSerialBaudFormatProtocol *Serial40K96008 Bit, None, 1 StopENQ/STXCG-TAB GraphicCharacter Set StandardCountry E-USA ASCIISelect Zero ONAuto-CR OFFAuto-LF OFFOption SettingMenu Lock ONLanguage EnglishPaperSingleForm AdjustTrac 1Form AdjustTrac 2Form AdjustAuto Sheet FeederForm Adjust12/7212/7212/7212/72Auto Tear OFFF-Eject OFFForm LengthTrac 1LinesStandardTrac 2LinesStandard6610.5”6610.5”Barcode OffBarmode UnsecuredTable 3.3 PRN Setup OptionsNOTE: Response times for CLIP loops may vary. CLIP loops must be tested to assure thatactuation of notification appliances occurs within 15 seconds after activation of an initiatingdevice.