Notifier AFP-3030 Operation Manual

Also see for AFP-3030: Programming manual Installation manual Operation manual Installation manual

Contents

Notifier AFP-3030 Operation Manual Manual pdf 2 page image

2 AFP-3030 Operations Manual — P/N DOC-01-033:C 05/12/2018Installation PrecautionsAdherence to the following will aid in problem-free installation with long-term reliability:WARNING - Several different sources of power can be con-nected to the fire alarm control panel. Disconnect all sources ofpower before servicing. Control unit and associated equipment maybe damaged by removing and/or inserting cards, modules, or inter-connecting cables while the unit is energized. Do not attempt toinstall, service, or operate this unit until manuals are read andunderstood.Verify that wire sizes are adequate for all initiating and indicatingdevice loops. Most devices cannot tolerate more than a 10% volt-age drop from the specified device voltage.Like all solid state electronic devices, this system may operateerratically or can be damaged when subjected to lightning inducedtransients. Although no system is completely immune from lightningtransients and interference, proper grounding will reduce suscepti-bility. Overhead or outside aerial wiring is not recommended, due toan increased susceptibility to nearby lightning strikes. Consult withthe Technical Services Department if any problems are anticipatedor encountered.Disconnect AC power and batteries prior to removing or insertingcircuit boards. Failure to do so can damage circuits.Remove all electronic assemblies prior to any drilling, filing,reaming, or punching of the enclosure. When possible, make allcable entries from the sides or rear. Before making modifications,verify that they will not interfere with battery, transformer, or printedcircuit board location.Do not tighten screw terminals. Over-tightening may damagethreads, resulting in reduced terminal contact pressure and diffi-culty with screw terminal removal.This system contains static-sensitive components. Alwaysground yourself with a proper wrist strap before handling any cir-cuits so that static charges are removed from the body. Use staticsuppressive packaging to protect electronic assemblies removedfrom the unit.Follow the instructions in the installation, operating, and pro-gramming manuals. These instructions must be followed to avoiddamage to the control panel and associated equipment. FACPoperation and reliability depend upon proper installation.The equipment must be correctly programmed and installed tosuit the specific application. Please ensure correct operationalparameters are set prior to commissioning. If further details on pro-gramming options are required, please consult the programmingmanual or contact our helpful technical support personnel.Documentation FeedbackYour feedback helps us keep our documentation up-to-date and accurate. If you have any comments or suggestions about ouronline Help or printed manuals, you can email us.Please include the following information:• Product name and version number (if applicable)• Printed manual or online Help• Topic Title (for online Help)• Page number (for printed manual)• Brief description of content you think should be improved or corrected• Your suggestion for how to correct/improve documentationSend email messages to:FireSystems.TechPubs@honeywell.comPlease note this email address is for documentation feedback only. If you have any technical issues, please contact TechnicalServices.EMC Warning:This is a Class A product. In a domestic environment, this product may cause radio interference in which case the usermay be required to take adequate measures.Electromagnetic Interface (EMI) tests are performed in accordance with Class A requirements of AS/NZS CISPR 22:2009