NovaTec Bessemer C Series Instruction Manual
                                        | |
Contents
| 
C-Series IM 1 MAY 2014112.0 MACHINE OPERATIONThe factory pre-sets allow the cutter to start production using the encoder input.If you want to use the encoder input,simply enter a length in the SETLENGTH box. A numeric screenwill pop-up. Enter the cut length andpress to return to the Quick Opsscreen. Enter the RPM’s in the samemanner, based on your experience.The cutter will run in ON DEMAND orCONTINUOUS MODE based on yourentries.12.1 Quick Ops Screen ItemsCut Parameter - Used to enter the value to control when the cutteractivates. It is dependent on the cut mode set on the recipe screen. It willalways show the product cut values when the system is stopped.Blade Speed - Enter the optimum blade speed for the cut whenrunning in On Demand mode. In Continuous Mode, this is greyed outand shows the currently running blade speed that is determined bythe calculation of Set Length and Line Speed.Measured Length - This is the length of the cut measured by theencoder signal. If an encoder is not used, this field will always bezero. It can be set up to always read the last cut length or hold thelast cut length for a specified time before showing the accumulatedcut length.Cut Mode Parameter UnitsEncoder Set Length in/mmEndSensor Delay Time secTime Cycle Time sec119© 2015 NOVATEC Inc. All Rights Reserved Document: C-Series 7 MAY 2015 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine