NovaTec Bessemer C Series Instruction Manual
                                        | |
Contents
| 
C-Series IM 1 MAY 2014This view shows the system cuttingproduct. The red Stop button hasdimmed and the green Cut Productbutton has lit up. The status box in thetop left hand corner has changed toindicate the current mode.The start count button was pressedand the counters are now incrementingwith each cut.In this view the Cut Scrap button waspressed and it is cutting scrap in timedcycle mode which is indicated in thestatus box and by the lighted cut scrapbutton. The field beneath the status boxnow shows Cycle Time in secondsinstead of Set Length in inches. This isthe parameter that controls when the cutcycle is activated and is dependent onthe operation mode. When stopped, italways shows the mode that is set forcutting product. The modes can bechanged on the recipe screen.This view shows the machine runningcontinuous mode which is a specialencoder mode of operation. This mode isautomatically activated when the cutlength and line speed causes too littletime between cuts for the system to runin On Demand mode. Notice that theblade speed is greyed out. The systemautomatically adjusts it to maintain theset length based on the line speed. Testcut is not available when running incontinuous.25© 2015 NOVATEC Inc. All Rights Reserved Document: C-Series 7 MAY 2015 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine