84 Novell Access Manager 3.1 SP1 Access Gateway Guidenovdocx (en) 19 February 2010Cluster Member: (Available only if the Access Gateway is a member of a cluster.) Select theserver you want to configure from the list of servers. The Listening Address(es) modificationsapply to the selected server. Any other modifications apply to all servers in the cluster.Listening Address(es): Displays a list of available IP addresses. If the Access Gateway hasonly one IP address, only one is displayed. If it has multiple addresses, you can select one ormore addresses to enable. You must enable at least one address by selecting its check box.TCP Listen Options: Provides additional options for configuring how requests are handled.See Section 1.7.1, “Configuring TCP Listen Options for Clients,” on page 59. At least one Webserver must be configured before you can modify these options.Listening Port: Specifies the port on which to listen for requests from browsers. The listeningaddress and port combination must not match any combination you have configured for areverse proxy.5 Configure the communication options between the tunnel and the Web servers by configuringthe following fields:Connect Port: Specifies the port that the Access Gateway uses to communicate with the Webserver.TCP Connect Options: Allows you to control how idle and unresponsive Web serverconnections are handled and to optimize these processes for your network. See Section 1.7.2,“Configuring TCP Connect Options for Web Servers,” on page 60.6 Specify a Web server to receive the traffic. In the Web Server List section, click New, specifythe IP address or DNS name of the Web server, then click OK.At least one Web server must be specified in the list before you can save a tunnel configuration.7 To save your changes to browser cache, click OK.8 To apply your changes, click the Access Gateways link, then click Update > OK.3.6 Setting the Date and TimeThe Date & Time option lets you set the system time for the Access Gateway.The time between the Identity Server and the Access Gateway must be either synchronized or set tobe within 1 minute of each other for trusted authentication to work.To configure the date and time options:1 In the Administration Console, click Devices > Access Gateways > Edit > Date & Time.
