Server Configuration Settings 97novdocx (en) 19 February 20104 In the Host Name(s) text box, specify a name for the host. Place each hostname on a separateline, then click OK.5 To add a new IP address and hostname, click New in the Host IP Address List section, thenspecify the IP address. In the Host Name(s) text box, specify a hostname, then click OK.6 To delete a host, select the check box next to the host you want to delete, then click Delete.7 To save your changes to browser cache, click OK.8 On the Server Configuration page, click OK, then click Update > OK.3.8.5 Adding New Network Interfaces to the Gateway ApplianceIf you add new network interface cards to the Gateway Appliance machine after installation, youneed to scan for these cards. Then you can configure them.1 In Administration Console, click Devices > Access Gateways.2 Click the name of the Access Gateway (this is usually the IP address) that you want to add aNIC to.3 On the Server Details page, click New NIC to scan for new network interface, then click OK toconfirm.You can click the Command Status tab to check if the scan has completed.4 Click Access Gateways, then click Edit for the cluster or server that has the new card.5 Click Adapter List. If the server is a member of a cluster, select the cluster member you want toconfigure.The newly added network interface is displayed here.6 In the newly added adapter section, click New, then configure the subnet mask and IP address.7 To save your changes to browser cache, click OK.8 On the Server Configuration page, click OK, then click Update > OK.
