Novexx Solutions AP 5.4 User Manual

Also see for AP 5.4: User manual Service manual User manual User manual Service manual

Contents

Novexx Solutions AP 5.4 User Manual Manual pdf 66 page image

66The material roll should turn in an anti-clock-wise direction when unwinding!4. Open the printhead contact lever [2C].5. Insert the material as illustrated [4][5][6].6. Push the material guiding [3D] towards thematerial edge. Be cautious not to wedge inthe material.7. Adjust the punch sensor. Shift the sensor atits handle [3E], until the pointer [3F] is placedabove the punch.Material with reflex mark: Place pointer 5 mmleft of the reflex mark.8. Close the printhead contact lever.9. Close the front hood.AP 5.4 with internal rewinderAdditionally guide the material end aroundthe deflector and fix it with the clamp to therewinder [5].AP 5.4 with dispensing edgeAdditionally remove 50 cm of labels from thebacking paper. Pull through the backingpaper end under the roll on the dispensingedge, place around the dispensing edge andfix with the clamp on the rewinder [6].Adjusting the printhead supportOnly set if material width < one half of print-head width:When printing on narrow label stock, it is pos-sible that the printhead will come into directcontact with the print roller in the area free ofmaterial. This can lead to premature failureon the printhead and can also cause a varia-tion in the darkness of the printout across thelabel.Therefore activate the printhead supportwhen printing on narrow label stock!The current position of the printhead supportis visible at the scale of the thumb wheel [3G].For wide material position „0“ is recommen-ded.1. For narrow material turn the thumb wheelclockwise, until the mark points to the „1“. Theprinthead is lifted slightly at its end.2. Print a label and check if the printout is consi-stent across the label. If not, turn the thumbwheel a little bit further.3. Repeat the steps 1 to 3 until the darkness ofthe printing is consistent across the label.User manual AP 5.4, topic section „Setup“,chapter „Inserting material“.CDChargement d'étiquettesA Disque de guidageB Mandrin d'adaptationC Levier de pression de la tête d'impressionD Glissage d'étiquettesE PoignéeF AiguilleG Roue de réglage[11] Poignée (A) sur le capot de l'imprimante.La description fournie aux chapitres suivantsconcerne la mise en place de rouleaux. Enalternative, il est possible d'utiliser des éti-FAVERTISSEMENT !Risque de coincement des doigts à lafermeture du couvercle du boîtier.– Toujours utiliser la poignée [11A] pourouvrir ou fermer le capot de l'imprimante.Risque de happement à proximité despièces rotatives– Ne jamais laisser les cheveux longs ou-verts (si nécessaire, porter un protège-cheveux).– Maintenir bijoux lâches, manches longuesetc. à l'écart des pièces rotatives de l'im-primante !– Fermer le capot de l’imprimante avantd’imprimer !Les rouleaux/supports en continu d'étiquet-tes peuvent peser plusieurs kilogrammes.Des chutes de rouleaux/supports en continud'étiquettes risquent d'occasionner des bles-sures.– Porter des chaussures de sécurité lors dumaniement de rouleaux/-supports en con-tinu d'étiquettes.– Stocker les rouleaux/supports en continud'étiquettes à un endroit sûr.La tête d’impression est chaude lorsqu’ellefonctionne !– Soyez vigilant !A