Novexx Solutions AP 5.4 User Manual

Also see for AP 5.4: User manual Service manual User manual User manual Service manual

Contents

Novexx Solutions AP 5.4 User Manual Manual pdf 85 page image

85Operating panelA DisplayB Feed buttonC Online buttonD Cut buttonE Prog buttonThe AP 5.4 has three different operatingmodes: offline, online and report mode. Thedisplay [A] shows the active operation mode.After powering-on, the printer is in onlinemode.Display messages are quoted here in thenational language, if it is provided by the prin-ter (otherwise in english). Refer to chapter 5to learn how to change the language setting.OnlineThe printer is ready to receive data. Print jobssent to the printer will be printed immediately.One of the following display messages mayappear:The printer is waiting forprint jobs.A print job is being sent;the print image is beinggenerated (--> point beside the 0).3 jobs are loaded, the firstof which is just being pro-ceeded. There are still 25labels to print.A print job has been stop-ped (by pressing Online).There are still 25 labels toprint. Continue by pressing Feed.Energy supply of the printhead: 75% of the maxi-mum level (activated bypressing Prog).Press Online to switch between online andoffline mode!OfflineThe following pictograms show the buttons,which have to be pressed (left side) and thedisplay after pressing those buttons (rightside). The pressed buttons are marked black.The printer is initially swit-ched offlineSlow feeding of label material and ribbon:GBONLINE 0 JOBSONLINE 0. JOBSONLINE 3 JOBSRestcount 25ONLINE 3 JOBSStopped 25Print contrast75%OFFLINE 0 JOBSFeedOnline OFFLINE 0 JOBSfeeding...Feeding of label material:Cut (if a cutter is mounted):Access to the parameter menu:Restarting the printer:User manual AP 5.4, topic section „Commis-sioning and Operation“, chapter „Operation inoffline mode“.Report modeStatus messages consistof a status number and ashort description.Acknowledge status messages by pressingOnline!The most important status messages:(M: = measure)5001: No punch detected. M: Check the ma-terial settings; Clean the punch sensor;Check the position of the punch sensor.5008: Ribbon end. M: Insert a new ribbon roll.5002: Material end. M: Insert new ribbon;Check the position of the material guiding.5005: Cutter fault (if mounted). M: Check thecutter sensor; Clean the cutter blades.Only dispenser version printers:5063: The locking lever at the backing paperfeed roller is opened. M: Close locking lever.5064: The diameter of the rewinded backingpaper roll is too high. M: Clear the rewinder.User manual AP 5.4, topic section „Statusreports“.OFFLINE 0 JOBSfeeding...FeedOFFLINE 0 JOBScutting...CutPRINT INFOProgSystem start…Cut Online FeedCDStatus no.: 5001No gap foundCD