Novra S300 User Manual

Also see for S300: User manual Setup guide User manual

Novra S300 User Manual Manual pdf 18 page image

Version: 1.00 Confidential and Proprietary 18 of 49NOTE: - Proper operation of IGMP protocol requires that all devices used in thenetwork support IGMP protocol.NOTE: The Device status can be sent to a remote management station by configuringthe status destination IP and port. However these settings don’t affect the broadcaststatus messages. To turn off the unicast status, set the destination IP address to255.255.255.255NOTE: - To turn off the status packets being sent to a unicast destination IPaddress, set the Status Destination IP to 255.255.255.255.1. Receiver IP: This is the IP address to be assigned to the receiver.2. Subnet Mask: This is the subnet mask that the receiver should use to determine whether an IPaddress belongs to the same network or not.3. Default Gateway: This is the IP address of the router that the receiver should use whenever itwants to send traffic to a non-local address.4. Enable IGMP Filtering: This check box allows the operator to turn IGMP filtering on or off.IGMP controls which multicast streams will be forwarded on the LAN based on the number ofclients listening to that stream.5. Status Destination Port: This is the UDP port used to send a copy of the status packets forremote monitoring applications6. Status Destination IP: This is the IP address used to send a copy of the status packets forremote monitoring applications7. Apply: By pressing this button, the updates are sent to the receiver8. Exit: Exits back to the main screen4.1.2 Satellite ButtonThe next step in the configuration is to ensure you have the correct RF settings and that the S300 cansuccessfully lock to your satellite signal. To configure your satellite settings, select the Satelliteconfiguration button and input the following fields: