Defender 5000 Indicators EN-173.2 Menu NavigationTo enter the Main Menu, press the buttonfrom any application home screen.Changing SettingsTo change a menu setting, navigate to that setting using the following steps:1. Enter the MenuFrom any Application screen, press the button. The Main Menu List appears on the screen.2. Select the Sub-menuScroll to the desired Sub-menu in the Main Menu List using the Softkey corresponding to the icon. Press the Softkey corresponding to the icon to display the Sub-menu items.3. Select the Sub-Menu ItemScroll to the desired Sub-menu Item using the Softkey corresponding to the icon .Press the Softkey corresponding to the icon to view the Sub-menu item’s settings.4. Select the SettingScroll to the desired Setting using the Softkey corresponding to the icon .Press the Softkey corresponding to the icon to select the setting.Press the Softkey corresponding to the icon to return to the previous screen.Press the Softkey corresponding to the icon to exit the menu and return to the last activeApplication mode.3.3 Calibration MenuThe TD52 indicator offers three calibration methods:Zero Calibration, Span Calibration and Linearity Calibration.NOTES:1. Make sure that appropriate calibration masses are available before calibration.2. Make sure that the scale base is level and stable during the entire calibration process.3. Calibration is unavailable with LFT set to ON.4. Allow the Indicator to warm up for approximately 5 minutes after stabilizing to room temperature.5. To abort calibration, press the Softkey corresponding to the icon 'X' anytime during the calibrationprocess.6. When any selection within the GMP menu is enabled, calibration results are automatically printed.3.3.1 Zero CalibrationZero calibration uses one calibration point. The zero calibration point is established with no weighton the scale. Use this calibration method to adjust for a different dead load without affecting the spanor linearity calibration.Calibration procedures:Long press the button to enter the MainMenu. Press the Softkey corresponding to theicon to enter the Calibration sub-menu.