OHAUS Defender 5000 TD52P Service Manual

Also see for Defender 5000 TD52P: Instruction manual

10 Defender 5000 Indicators Service Manual1.7.3 RS232 Interface Cable to TD52XWPass the optional RS232 cable through the strain relief (Figure 1-2, item 10) and attach it to terminal blockJ5 (Figure 1-3, item 7). Tighten the strain relief to maintain a watertight seal.1.7.4 MICRO SD Card InstallationThe SD memory card can be used for additional storage in the Checkweighing and Counting applications.Figure 1-8 shows the installation of an SD card into the socket on the edge of the TD52P andTD52XW mainboard.Figure 1-8 Sliding an SD Card into the SD Socket (left); SD Card Installed (right)1.8 TD52XW Rear Housing OrientationThe TD52XW is delivered in the wall mount orientation with the connections exiting below the display. Therear housing may be reversed so the connections exit above the display when the TD52XW is placedhorizontally on a bench. To reverse the rear housing, remove the four Phillips head screws, carefully rotatethe housing 180°, and reinstall the screws.Figure 1-9 Wall Mount Configuration Figure 1-10 Bench Top Configuration1.9 Mounting BracketAttach the bracket to a wall or table using fasteners (not supplied) that are appropriate for the type ofmounting surface. The bracket will accommodate up to 6 mm (1/4”) diameter screws. Locate the mountingholes as shown in Figure 1-11.