OHAUS Defender 5000 TD52P Service Manual

Also see for Defender 5000 TD52P: Instruction manual

29 Defender 5000 Indicators Service ManualSelect the string number in the first selection box then any existing data for that string will be shown in the secondentry box. Using the alphanumeric keys, enter or edit the characters to be used as the selected string.String 1 = OHAUS (Default)String 2 = T52 (Default)2.9.2.12 ResetReset the settings to factory default.2.9.3 RS485 ConfigurationPlease refer to RS485 Configuration in the Defender® 5000 RS232/RS485/USB Interface InstructionManual.2.9.4 Ethernet ConfigurationPlease refer to Configuration in the Defender® 5000 Ethernet Interface Instruction Manual.2.9.5 Wifi ConfigurationPlease refer to Wifi Configuration in the Defender® 5000 USB Host Instruction Manual.2.9.6 Bluetooth ConfigurationPlease refer to Bluetooth Configuration in the Defender® 5000 USB Host Instruction Manual.2.9.7 AnalogPlease refer to Analog Configuration in the Defender® 5000 Analog Kit Instruction Manual.2.10 Service MenuEnter this menu to check the loadcell, software update and factory reset etc., the password (64852) is amust for this operation.2.10.1 RAMPThe ramp display shows the percentage of use of the A to D circuit, that is, of the temperature-compensatedduty cycle. The actual value is not as important as how it changes. It should increase as the weight on thebalance is increased. The ramp display should remain constant without fluctuations.The normal range is within 3% to 97%. If the readings are outside this range the load-cell is likely bad.Fluctuations in the display may indicate a mechanical interference, a cable connection problem, a damagedMain PCB or a damaged load-cell.2.10.2 Expand