Page 3-343-3 Address Editor1. Network/Administrator Tabs ........ Click on the desired tab to switch between network and administrator settings.2. Host Name ..................... Type the host name of the scanner (up to 32 single-byte characters) in thisfield.3. IP Address ..................... Type the IP address of the Scanner Interface Card in this field in the followingform: XXX.XXX.XXX.XXX Whenever you attempt to change the IP address, aconfirmation dialogue box will appear in which you will need to verify that youreally want to change the address.4. Subnet Mask .................. Type the subnet mask of the Scanner Interface Card in this field in thefollowing form: XXX.XXX.XXX.XXX5. Default Gateway ............ Type the default gateway of the Scanner Interface Card in this field in thefollowing form: XXX.XXX.XXX.XXX* This is used for transmitting packets to another network or subnet.6. DHCP/BOOTP ................ The DHCP and BOOTP can be set to either “ON” or “OFF”. The factorydefault setting is “ON”.7. RARP .............................. The RARP can be set to either “ON” or “OFF”. The factory default setting is“ON”.8. DNS Server (Pri.) ........... When a host name is used for transmitting data under an environment thatuses a DNS server, type the IP address of the primary DNS server in this fieldin the following form: XXX.XXX.XXX.XXX9. DNS Server (Sec.) ......... Type the IP address of the secondary DNS server in this field in the followingform: XXX.XXX.XXX.XXX10. DNS Domain Name ....... Type the domain name (up to 32 single-byte characters) in this field.11. WINS Server (Pri.) ......... When WINS (Windows Internet Name Service) is used to resolve the IPaddress using the name of the computer, type the IP address of the primaryWINS server in this field in the following form: XXX.XXX.XXX.XXX
