Page 3-1173-6 Configuration Tool3. Enter the Ethernet address of the Scanner Interface Card in the Ethernet Address field (e.g. “00 c0 ee10 00 0d”). The Ethernet address is listed on the label that is attached near the connector on theScanner Interface Card.4. Enter the IP address that the network administrator gives you for the Scanner Interface Card in the IPAddress field (e.g. “192 168 110 171”).5. Click on the OK button. Follow the instructions on-screen in order to reboot the Scanner Interface Card.After rebooting, the Scanner Interface Card should appear in the AdminManager display.Next, the Subnet Mask and Gateway address can be registered.• Registering the Subnet Mask and Gateway address1. Click on the Scanner Interface Card in the AdminManager display to select it.2. Under Setup in the Menu Bar, select Protocols.3. Click on the TCP/IP Tab.4. Enter the Subnet Mask and the Default Gateway address in the appropriate fields.5. Click on the OK button. Follow the instructions on-screen in order to reboot the Scanner Interface Card.
