316 10.WHEN THIS MESSAGE APPEARS106. “READY (CHECK SADDLE STITCH STAPLER)”This message will be shown only when the Saddle Stitch Finisher (optional: 9286) is installed. It appearswhen the staples in the stapler of the Saddle Stitch Finisher run out or when the staples in the SaddleStitch Finisher are jammed.Remove the jammed staples according to the procedure in P.313 “5.“Examine stapler in the SaddleStitch Unit””.If the staples run out, follow the procedure below as well as the procedure in P.304 “2.“Check staplecartridge in the Saddle Stitch Unit””.1 Follow steps 1 to 6 of P.304 “2.“Check staple cartridge in the Sad-dle Stitch Unit””.• Do not close the front cover of the Saddle Stitch Finisher.2 Check the following 2 items to perform test stapling.• Whether the Saddle Stitch Finisher is securely installed in the equipment.• Whether any LD or LT-R paper is set in the equipment.3 Close the front cover of the Saddle Stitch Finisher.• Test stapling is automatically performed.If the front cover of the Saddle Stitch Finisher is closed without satisfying the condition of step 2, test stapling isnot performed. Test stapling is necessary to prevent void stapling. After satisfying the condition of step 2 andopening/closing the front cover of the Saddle Stitch Finisher again, be sure to perform the test stapling.
