42615101TH Rev.8 143 /Oki Data CONFIDENTIAL5.4.2.4 Motor and clutch testThis self-check is used for motor and clutch testing.1. Go into the self-diagnostic (level 1) mode, press the MENU+ or MENU- key until upper displayof “MOTOR & CLUTCH TEST” is brought up, and press the ENTER key (the MENU+ keyincrements a test item and the MENU- key decrements a test item).2. The names of units to be tested are listed in table 5-5. Use the MENU+ or MENU- key until thename of a unit that is to be tested appears on the lower display (the MENU+ key increments anitem and the MENU- key decrements an item).3. Pressing the ENTER key starts the test of the unit, blinking the displayed name of the unit. Theunit is driven for 10 seconds (refer to figure 5-2).Note! The view of step 2 is restored after the 10-second driving, and the unit is driven againwith the press of the corresponding switch.• Clutch solenoid on-off operations are repeated in normal printing driving (solenoidswhose mechanical structures do not permit their single driving operate motorsconcurrently with them).4. Use the CANCEL key to stop the drive of the unit (the display for the unit remains the same).5. Repeat the cycle of steps 2 through 4 as needed.6. Pressing the BACK key ends the test (the display is restored to step 1).MOTOR & CLUTCH TESTK - ID - ID MOTOR
