Oki C3530nMFP Maintenance Manual

Also see for C3530n MFP: Configuration guide Installation Network user's guide Setup guide User guide

Contents

Oki Data CONFIDENTIAL43605601TH Rev. 1 113 /• CU serial number is shown in the Printer Serial Number Column in the header of StatusPage. Therefore, the confirmation of the CU serial number after the change can be doneby printing the Status Page.• The PU serial number is shown in the Lot Number: column of the last line which is in theheader of the MenuMap.(2) [When not facing OEL](2-1) Set the PU serial number(Maintenance utility operation manual, Section 2.4.1.2, PU circuit board setting)SAP serial number can be applied to the device. The SAP serial number is displayedin the highest rung of the serial number label. It is a 12-digit number includingproduction place (2 digits), production year (2 digits), sequence number (6 digits)and revision number (2 digits).• PU serial number is a 10-digit number which is basically the same as SAP serial numberexcept that it has no the 2-digit revision number.• Set on the menu of [Section 2.4.1.1.2.1, PU serial number setting] of [Section 2.4.1.1.2PU circuit board setting function].• If you want to specify the PU serial number, please add a “0” (a normal-width zero)then input the 11-digit number. (Please notice that when read out, the number will be 10digits.)As shown in the following image, on the menu of [PU serial number setting], eliminatethe 2-digit revision number then add a normal-width zero to the 10-digit number andinput it.Add one-byte 0 to the top of 10-digit figure of 12-digit SAP serial number to set.Set "0AE01234567" in the setting screen of PU serial number.RevisionA B CMade inA E 0 1 2 3 4 5 6 7 8 9Figure of Serial No. label image• PU serial number will be output to the Printer Serial Number column in the header ofStatus Page. For this reason, check of PU serial number is performed by printingStatus Page.• After the configuration in the UK factory, when facing OEL, the PU serial number is takenas Lot Number and shown in the Lot Number: column of the last line which is in theheader of the Status Page.(2-2) Set the CU serial numberCU serial numbe setting is unnecessary When not facing OEL.