- 58 -2. Setting UpWireless LAN (AP mode) directly connects wireless devices (computers, tablets,smartphones, etc.) to the machine without using a wireless LAN access point.• If there is metal, aluminum sash, or a reinforced concrete wall between the machine and wireless devices,connections may be harder to be established.• Up to four devices can be connected to the machine via the wireless LAN (AP mode). The fifth device will be rejected.• Automatic connection (push-button)If your wireless devices support WPS-PBC (push button), you can connect to the wirelessLAN (AP mode) with the WPS button.• Manual SetupIf your wireless devices do not support WPS-PBC (push button), you can enter [SSID] and[Password] of the machine in your wireless devices to connect to the wireless LAN (APmode).Automatic connection (push-button)If your wireless devices support WPS-PBC (push button), you can connect to the wirelessLAN (AP mode) with the WPS button.1 Confirm the position of the WPS button on your wireless device by the manualattached to the device.2 Turn the machine on.If the [Do you want to Set-up wireless?] message appears, select the [Do not show next time.] check box, andthen press [No].3 Press [Device Settings] on the touch panel.4 Press [Admin Setup].5 Enter the administrator name and password and press [OK].The factory default administrator name and password are "admin" and "999999"respectively.6 Press [Network Menu].7 Press [Network Setup].8 Press [Wireless(AP Mode) Setting].The message below is displayed for about five seconds.Connecting to the Machine Directly
