44015503TH Rev. 1 120 /Oki Data CONFIDENTIAL 5. MAINTENANCE MENUS5.1 system Maintenance menu (for maintenance personnel)Turning on each printer while the MENU up-arrow ( ), MENU down-arrow ( ) and HELPbutton combination is used on its operator panel starts its System Maintenance menu. Themenu is displayed in English irrespective of the destination of the product.Note! The menu allows for changing parameters such as the destination of theprinter and is transparent to end-users of the printer.Table 5-1: Maintenance menu display tableCategory Option (1st row) Settings(2nd row) DF FunctionSystemMainte-nanceEnter Password ************000000Enters a password to enter the SystemMaintenance menu. The password defaultsto 000000. Six to twelve alphanumericcharacters can be entered as the password.OKIUSER ODAOELAPSJP1JPOEM1OEMAOEML* Sets any of the destinations:JPOEM1 (OEM in Japan); OEMA(Overseas OEM of A4-size-default printer);and OEML (Overseas OEM of Letter-size-default printer).The printer is rebooted automatically afterthis option is exited.Mainte-nanceMenuDisplay condition:The security hard disk function is disabled.Format HDD Execute - Initializes an HDD. Pressing the Enterbutton displays the confirmation message:Are you Sure?yesNoNo restores the display of this menu. yesexits the menu, starting formatting an HDDthat has been installed on the printer.Display condition:An HDD has been installed on the printer(Boot Menu-Storage Setup-Enable HDDhas been set to yES).Category Option (1st row) Settings(2nd row) DF FunctionSystemMainte-nanceMainte-nanceMenuFormat FlashROMExecute - Initializes flash ROM. Pressing the Enterbutton displays the confirmation message:Are you Sure?yesNoNo restores the display of this menu.yes exits the menu, starting formattinga resident (on-board) flash device of theprinter.* never use this option.ResetEEPROMExecute - Resets the information in EEPROM tofactory default settings. The printer isrebooted automatically after that.* This does not initialize part of specialinformation in the EEPROM.Maintenance Print Menu EnableDisable *Sets whether to enable or disable displayof ‘Print Information’-‘ID Check Pattern’ and‘Engine Status’. Disable does not displaythem in the Function menu. After changeof the setting for this option, exiting itrestarts the printer.Fuse Keep Mode Execute - Places the printer online, a command beingissued from the CU to PU, when the Enterbutton is pressed. With the printer on, aconsumable of the printer can be replacedwith a new one, and then the printer canbe checked for proper operation (where,not breaking the new one’s fuse, the printerdoes not count consumption as the life ofthe consumable replaced with the one).Turning off the printer ends the checkmode, and then turning it on disables themode.
