Oki C810 Maintenance Manual

Also see for C810: User guide User guide Setup guide Maintenance manual Guías del usuario

Contents

Oki C810 Maintenance Manual Manual pdf 31 page image

44072903TH Rev.1 31 /Oki Data CONFIDENTIAL 3. INSTALLATION3.1 Cautions, and do’s and don’ts• Do not install the printer in any high-temperature location or a near heat source.• Do not install the printer in a location where chemical reaction may occur (laboratory andthe like).• Do not install the printer in the proximity of inflammable solvents, such as alcohol andpaint thinner.• Do not install the printer within reach of children.• Do not install the printer on an unstable surface (e.g., on a rickety bench or on a slantingplace).• Do not install the printer in a location with moisture or heavy dust, or in direct sun.• Do not install the printer in an environment with sea wind or corrosive gas.• Do not install the printer in a location with heavy vibration.• In the event that the printer is inadvertently dropped or its cover is damaged, remove thepower plug from the power outlet and contact the customer information center.Such mishap could lead to an electric shock, fire or injury.• Do not connect any power cord, printer cable or grounding wire in any other manner thanthe way specified in the manual. Failure to observe the above could result in fire.• Do not stick in an object into the vent hole.Such action could lead to an electric shock, fire or injury.• Do not place a glass filled with water or the like on the printer.Such action could lead to an electric shock or fire.• When the printer cover is opened, be careful not to touch the fuser unit.It may cause burns.• Do not throw the toner cartridges or the image drum cartridges into fire.Dust explosion could cause burns.• Do not use a highly combustible spray near the printer.It may case a fire because the printer contains parts that get extremely hot.• In the event that the cover becomes unusually hot, emits smoke, bad smell, orabnormal noise, remove the power plug from the power outlet and contact the customerinformation center.It may lead a fire.• If water or any other liquid enters the inside of the printer, remove the power plug fromthe power outlet and contact Customer Center.Fire could break out.• If someone drops foreign objects such as a clip in the printer, remove the power plugfrom the outlet and take out the foreign objects.It may cause an electric shock, fire, or injury.• Do not operate or disassemble the printer in any other manner than the way specified inthe manual.Failure to observe this warning could result in an electric shock, fire or injury.• Do not install the printer in a location where its vent hole is blocked.• Do not install the printer directly on a shag carpet or rug.• Do not install the printer in a sealed room or other location with poor ventilation orpermeability.• Make sure to ventilate sufficiently when continuously using the printer in a small room fora long time.• Install the printer away from a strong magnetic field or noise source.• Install the printer away from a monitor or TV.• To move the printer, hold both sides of the printer.• This printer, which weighs approximately 40 kg, should be lifted by two or more people.• While the printer power is on or the printer is printing, do not come close to the paperexit. Such action could lead to injury.When the precautionary notes concerning the installation and operation are explained, theuser should be referred to the precautionary notes given in the user’s manual. Especially, givethorough explanation on the power cord and the grounding wire.