MB260- 29 -6 - Network featuresSetting up the PCFor this section, refer to the instructions supplied by themanufacturer of the WLAN USB key to help you to findand join the "house" network.1 You may need to install the software for the WLANUSB key on the PC, if this has not already beendone.2 Plug WLAN USB key into a USB port on the PC.3 Use the software of the WLAN USB key to detectthe network.4 Join the network "house" once this has beendetected.5 Now set up the WLAN network connection of yourPC.To do this, you must configure the elementProtocol Internet (TCP/IP) for the WLANconnection that has been created. If this element isset up in such a way as to obtain an IP addressautomatically, you must change it to manual modeto set up the TCP/IP address ("169.254.0.1" in ourexample), the subnet mask ("255.255.0.0" in ourexample) and the default gateway ("0.0.0.0" in ourexample).6 Enter OK.NoteTo guide you through this stage, referto the paragraph “Setting theparameters for a connection” in themanufacturer’s instructions.
