Oki MB760dnfax User's Manual And Troubleshooting Manual

Also see for ES7170dfn MFP: User manual User manual User manual User manual

Contents

Oki MB760dnfax User's Manual And Troubleshooting Manual Manual pdf 27 page image

TROUBLESHOOTING FOR COPYING- 27 -2134567● TROUBLESHOOTING FOR COPYINGCopying ProblemsSee the table below when you have a problem in operating copy function or have an unexpected copy output.Problem Description Cause Corrective ActionFunctions cannot be set. Another function that is unavailable for thecombination has already been set.Some functions cannot be combined.For details, refer to Advanced Guide.Copying stops during scanning ofthe originals. (The message “Thenumber of originals exceeds thelimits Will you print out storedoriginals?” appears.)The number of scanned pages has reachedthe maximum.To copy the scanned images, press [YES]. To cancel, press[NO].Copying stops during scanning ofthe originals. (The message “Notenough Work Space to storeoriginals Will you print out storedoriginals?” appears.)No available internal memory remains. To copy the scanned images, press [YES]. To cancel, press[NO].Copied image is too light. No toner is left. The message “Install new Black cartridge” appears when notoner is left. Replace the toner cartridge. P.57 "Replace the Print Cartridge"Copy density is set too light. Darken the density manually or try the automatic density mode.Copied image is too dark. Copy density is set too dark. Lighten the density manually or try the automatic densitymode.Copied image has stains. The Reversing Automatic Document Feederis not fully lowered.Lower it fully to block outside light.The original glass, platen sheet, scanningarea and guide are stained.Clean them.The copy density is set too dark. Lighten the density manually or try the automatic densitymode.A transparent original such as a transparencyor tracing paper is being used.To copy a transparent original clearly, put a sheet of blank,white paper behind the original. Make sure that the paper islarge enough to cover the original.Copy image is skewed. The original is sent from the ReversingAutomatic Document Feeder at a skew.Replace the original while aligning the side guides of theReversing Automatic Document Feeder to its width so that itwill be placed straight.Copied image is partially missing. The size or orientation of the copy paper andthat of the original are not consistent. Thereduction ratio is not properly set.Fit the copy paper size to the original or set the reduction ratiofor the copy paper.The binding margin is too wide. Set the binding margin width to fully cover the original.For details, refer to Chapter 2 of the Advanced Guide.The original is larger than the printable area. The outside part of the printable area cannot be copied.Copied image is blurred. There is a gap between the original glass andthe original.Lower the Reversing Automatic Document Feeder fully so thatthe original fully contacts the platen glass.The copy paper is damp. Replace it with dry copy paper.