Technical Reference Guide – Operator interface > 81FUNCTION> Prints in 10 CPI Utility mode.> Both parallel and USB interfaces are available.> Paper auto Skip Over Perforation (SOP) by menu defaultvalue continuous for both. If SOP is enabled, one inchfrom the bottom of the paper will not be printed.> Printing starts when more than 16 bytes of data arereceived (line full).CONTINUOUS PAPER AUTO-LOADINGLoad continuous paper on the tractor (at a position such that thepaper does not cross the paper-end sensor).In this situation, pressing the LOAD/EJECT switch starts auto-loading.When the paper does not cross the paper-end sensor within an8-in feed of the paper, a paper-end state occurs.The print position of the first data line can be set by menufunction or in first character setting mode.NOTECONTINUOUS PAPER AUTO-PARKINGWith continuous paper loaded in continuous paper mode,pressing the PARK switch starts auto-parking.When the end of continuous paper is detected by the time thepaper is fed 22 in reverse, auto-parking finishes and a paper-endstate is established.If the end of continuous paper is not detected after a 22-inreverse feed, auto-parking terminates. The position that is setwhen the auto-parking terminated becomes TOF.Pressing the PARK switch again repeats the auto-parkingoperation.TOF is the position that is set when the operation wascompleted properly.
