– –3-7. Loading the Paper RollBe sure to use paper roll that matches the printer’s specification.Cover open leverPaper rollTension bar1 Push the cover open lever and open the printercover.2 Set the paper roll in the direction as shown, and pullon the leading edge of the paper towards you.Note: Make sure not to pass the paper under thetension bar. In the following condition,remove the tension bar unit and change theadjustment lever position in accordance withthe procedures described in paragraphs --and --:• Paper thickness between 100 μm and 150μm, or paper width of 57.5 mm on thevertical/wall-mount layoutNote: When using a paper roll with an . mmwidth, remove the paper roll holder in ac-cordance with the procedure described inparagraph --.3 Push both sides as shown in order to close theprinter cover.Note: When closing the printer cover, make sureboth sides close firmly, not just one side.
