– 6 –Notes on Using the Auto Cutter1) To print after a cut, feed 1 mm (8-dot line) or more of paper.2) If the cutter is not in its home position after an error, first eliminate the cause of the error;then, turn the power back ON.3) If the printer is placed horizontally, the use of the partial cut is recommended. If you usethe full cut, the cut pieces of paper may fall into the paper outlet passage, causing a paperjam as a result of cutting multiple pieces of paper. Therefore, do not use the full cut if theprinter is placed horizontally.4) If you use the full cut, make sure to remove the piece of paper after each cut.5) Do not attempt to remove the paper during a cut, as this can cause a paper jam.
