– –4. Attaching the AccessoriesThe following accessories do not necessarily have to be attached.Attach them if necessary.• Holding plate• Cable cover• Switch blindShaft82.5 or 79.5 mm width 57.5 mm width4-1. Attaching the Holder Plate() Attach the shaft to the printer.(2) Wipe the area into which the rubber feet will be affixed in order to remove any grime; then,affix the roll stoppers. The positions for affixing them will vary depending on the paperwidth.() Use a regular screwdriver to remove the clips atboth ends of the bar to remove the tension barunit.Push in the left andright ends of the shaft.
