Oki Operation 790 Handbook

Also see for MICROLINE 790: Handbook

Contents

ML790/791 Printer Handbook 77Important! This feature also prevents access to the Menu. To access the Menu, turnthe printer off, then hold down the SEL key while turning on the printer.Page Length. 11” (factory default), 11 2 / 3”, 12”, 14”, 17”, 5”, 3”, 3.5”, 4”, 5.5”, 6”, 7”, 8”,8.5”. Selects the length of the paper you’ll be using in your printer. This enables theprinter to keep track of the initial printing position on each page (Top of Form).Page Length Control. Choose page length control system for SASF mode.by Actual Page Length ..... Control page length by actual physical page length.by Menu Setting ................ Control page length by logical page length.Page Width. Appears in Menu for wide-carriage model only. Choose a page width of8” (factory default) or 13.6”.Paper out Override. No (factory default) or Yes. The paper out detector senses whenless than an inch of paper remains in the printer and stops printing at that point.Changing this setting to Yes overrides the detector so you can print closer to the bot-tom of the page if you’re using single sheets. Be careful if you use this feature: it letsthe printer continue printing when there’s no more paper, which can cause loss ofdata and may damage the printhead.Parity. Appears only if optional Serial Interface is installed. None (factory default),Odd, or Even. Selects the type of parity your system uses.Pin 18. +5V (factory default) or Open. Sets the signal on pin 18.Pitch. 10 cpi (factory default), 12 cpi, 15 cpi, 17.1 cpi, or 20 cpi. Selects the characterwidth measured in characters per inch (cpi).Power Save Time. 5 min (factory default), 10 min, 15 min, 30 min, 60 min. Sets thetime until the printer enters the power save mode. This setting is effective when thepower saving option is enabled.Power Saving. Enable (factory default) or Disable. Enables or disables the power savemode. When the power save mode is enabled, the printer enters the power save modewhen the time set in the Power Save Time option elapses while the printer is idle. TheSEL LED flashes and other LED turn off when the printer enters the power save mode.