40496501TH Rev.1 965.2 LubricationThis printer is designed to be maintenance free and requires no lubrication during normaloperation. However it is necessary to apply lubricant in case the printer is disassembled,reassembled, cleaned or parts have been changed.(1) Cleaning timeRemarks:1) Turn off the power before cleaning.2) Make sure that paper dust will not fall inside of the machine.• Cleaning period:6 months of operation or 300 hours of operation, whichever the earlier.• Cleaning points:Carriage shaft and surroundings: Remove paper and ribbon dust.Paper path: Clean stains and dusts.Paper End Sensor Remove the dust on the Sensor.Paper Width Sensor Remove the dust on the Sensor.Ribbon Jam Sensor Remove the dust on the Sensor.Paper Out Sensor Remove the dust on the Sensor.Paper Jam Sensor Remove the dust on the Sensor.(2) Lubricant• Pan motor oil (or equivalent): PM• Albania grease (or equivalent): GEP(3) Amount of lubricant• Medium amount A : Apply three to four drops of oil, or 0.008 inch(0.2mm)thick grease.• Small amount B : Apply one drop of oil(0.006±0.002 g)(4) Areas to AvoidNo123456789Do not lubricateInk ribbonSensorPlaten (printing face)Feed roller (rubber face and resin face)Pitch beltHead cableMicro switchPin tractor surfaceAuto gap discReasonTo prevent blurring of printTo prevent dust adheringTo prevent stained paperTo prevent stained paperTo prevent rubber degradationTo prevent deteriorationTo prevent stained paperTo prevent contactsTo prevent dust adhering
