34INTERRUPTING A COPY RUNA copy run can be temporarily interrupted to allow another copy job to be performed. When the other job is finished,the copy run will resume using the original copy settings.1 Press the [INTERRUPT] key ( ) tointerrupt the copy run.The [INTERRUPT] key( ) blinks until themachine is ready for theinterrupt job, after whichit lights steadily.If you decide to cancel theinterrupt job while selectingsettings, press the[INTERRUPT] key ( ).2 Remove the previous original(s) andplace the original(s) of the interruptcopy job. (p.22, p.23)3 Select the number of copies and anyother desired copy settings, and thenpress the [START] key ( ).The interrupt copies willbe offset from theprevious copies. (Offsetfunction, p.35)4 When the copy job is finished, pressthe [INTERRUPT] key ( ) and removethe original(s).5 Replace the previous original(s) andpress the [START] key ( ) to resumecopying.Replace only the originals that have not yet beenscanned.Automatic two-sided copying, sort/group copying, staple sort, cover copy, pamphlet copy, mixed feeding, jobbuild, job programs, or multi shot copying cannot be used for interrupt copying.Note• If audit mode is enabled, a message willappear prompting you to enter youraccount number. Enter your accountnumber with the numeric keys. The copiesthat you make will be added to youraccount’s count.• If an original is being scanned when the[INTERRUPT] key ( ) is pressed, theinterrupt job will begin after the original isscanned. If a copy is being printed, theinterrupt job will begin after the copy isprinted.Note
