Manuals database logo
manualsdatabase
Your AI-powered manual search engine

PAT DS 350 Operator's Manual

Also see for DS 350: User manualTroubleshooting manualReplacement instructions

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Page 30 preview
Page 31 preview
Page 32 preview
Page 33 preview
Page 34 preview
Page 35 preview
Page 36 preview
Page 37 preview
Page 38 preview
Page 39 preview
Page 40 preview
Page 41 preview
Page 42 preview
Page 43 preview
Page 44 preview
Page 45 preview
Page 46 preview
Contents
  1. Table Of Contents
  2. GENERAL INFORMATION
  3. WARNINGS
  4. SYSTEM DESCRIPTION
  5. System Function
  6. Control Identification
  7. CONFIGURATION SETUP
  8. Quick Setting of the Reeving
  9. Quick Hoist Line Selection
  10. Anti-two Block (A2B) Switch(es)
  11. OPERATION
  12. LIMIT Setting
  13. Tip Height Limitation
  14. Boom Angle Limitation
  15. Radius Limitation
  16. INFO crane configuration
  17. Display Contrast Control
  18. Display Dimmer
  19. Pre-Operation Inspection and Calibration Verification
  20. SERVICE AND MAINTENANCE
  21. ERROR CODES
PAT DS 350 Operator's Manual Manual pdf 38 page image
Operator's Manual DS 350 / 1361 RT 875 CC© PAT Revision E // SB // 09/03/02 190137_E327 SERVICE AND MAINTENANCEDaily maintenance of the load moment indicator consists of inspecting:The electrical wiring connecting the various parts of the system.If electrical wiring is damaged, it shall be replaced immediately.If the insulation is worn on the length sensor cable or cable guides are damaged, theseparts shall be replaced.Check the anti two-block limit switches for freedom of movement.The cable reel shall be under tension to operate properly.Check the pressure transducers at the hoist cylinder(s) and the connecting hoses for oilleakage.Other than correcting the problems identified in the ErrorCodes Table and replacing faultymechanical parts and cables, no other repairs shall be performed by non expert personnel.
/ 46
This manual is suitable for:
DS 350
Manuals database logo
manualsdatabase
Your AI-powered manual search engine