Error Codes© PAT Revision E // SB // 09/03/02 190137_E338 ERROR CODESERRORCODEERROR CAUSE ACTION (Refer to ServiceManual for detailed Action)E01 Minimum radius ormaximum anglerange exceededFallen below theminimum radius or abovethe angle given in theload chart due to raisingthe boom to far.Lower boom back to aradius or angle given in theload chart.E02 Maximum radius orminimum anglerange exceededThe maximum radius orminimum angle given inthe load chart wasexceeded due to loweringthe boom too far.Raise boom back to aradius or angle given in theload chart.E04 Operating mode notavailableOperating mode switch inthe console setincorrectly. Operatingmode is not permissiblewith actual craneconfiguration.Set operating mode switchcorrectly to the codeassigned to the operatingmode of the crane.E05 Length range notpermittedBoom has been extendedtoo far or not far enough.Length sensoradjustment changed; i.e.length sensor cable slidoff the cable drum.Retract or extend boom tocorrect length given in theload chart. See Section 6.E07 No acknowledgmentsignal from overloadrelay.Overload relay isdefective or not beingselected.Replace terminal board.E08 No acknowledgmentsignal from Anti-Two-Block switchrelay .Anti-Two-Block switchrelay is defective or notbeing selected.Replace terminal boardE11 Fallen below limitfor the analogchannel “length”.a.) Cable between lengthsensor and central unitdefective, not connectedor water in theconnectors.b.)Length sensorPotentiometer defective.c.)Electronic componenton analog input moduledefective.a.)Check cable andconnector and replace, ifnecessary.b.)Replace and reset lengthsensor Potentiometer.c.)Replace analog inputmodule and reset pressurechannels.