Panasonic 78A1LJ Operating Instructions Manual

- 19 -V. MAINTENANCE• Use only a dry, soft cloth for wiping the unit. Do not use a damp cloth, thinner, ben-zine, or other volatile solvents for cleaning.• In the event that the inside of the tool or battery pack is exposed to water, drain andallow to dry as soon as possible. Carefully remove any dust or iron filings that col-lectinside the tool. If you experience any problems operating the tool, consult with a repairshop.VI. ACCESSORIESCAUTION:To prevent the risk of injury, only use accessory or attachment for its stated purpose.Bit adapter (included)•EY9HX403EDrill chuck (Optional accessory)•EY9HX400EUse with wood drill bit or metal drill bit with shank of 1.5 mm to 13 mm diameter.Do not use the drill chuck in “Rotation with hammering mode” ( ). Use in "Rotationwith hammering mode" may cause break of chuck or bit and result in injury.Hammer chuck (Optional accessory)•EY9HX401EUse with concrete drill bit, wood drill bit or metal drill bit with straight shank of 2.5 mmto 13 mm diameter.Do not use the hammer chuck with wood drill bit or metal drill bit in “Rotation withhammering mode” ( ). Use in “Rotation with hammering mode” may cause breakof bit and result in injury.If you need any assistance for more details regarding these accessories, ask yourlocal service center.VII. USAGE SUGGESTION1. If there isn’t enough force pushing down on the bit, the tool may not be able toblow in hammering mode.This is to prevent the hammering mode from operating with no load. Press downharder on the bit to engage the tool and cause it to blow.2. In winter or in other situations where the temperature of the unit is low (5°C (41°F)or below), the blow of the hammering mode may be weaker than normal at the be-ginning stage.This is because the grease becomes stiffer in low temperatures, increasing fric-tion.If this should happen, operating hammering mode with no load for approximately30 seconds and repeat this 3 times. This will restore its blowing power.