5.4 How to Install Add-on CassetteThe add-on cassette is fitted with the control unit using the provided screws.Note:The add-on cassette must be secured with the control unit using the screws in the actual use forpreventing the affect of vibrations.The backup battery (option) should be before installing the add-on cassette.The installation must be carried out when the power supply is off. If the power supply is on, it may causefaults.Recommended screwRecommended screw Size and other conditions QuantityTapping screw Material: SW pan head (+) P-tight 2.6-16galvanization, trivalent chromate (black) 2 pcs/1 cassette5.4.1 Installing Communication CassetteNote:The communication cassette can be installed only in the cassette mounting part 1 of the controlunit.Installation on the control unitConnect the connector on the back of the communication cassette and the connector of the cassettemounting part of the control unit, and secure the two positions, bottom left and top right, with the screws.It is no problem if the ribs remain. (AFPX-COM5 has no rib.)The screw’s tightening torque should be 0.3 to 0.5 N･m. Screw securely.Installation on the application cassetteRemove the cover of the application cassette that was secured previously.Connect the connector on the back of the communication cassette and the connector at the front of theapplication cassette, and secure the two positions, top left and bottom right of the communicationcassette which the ribs were cut, with the screws. (AFPX-COM5 has no rib. Install it after the wiring ofthe application cassette.)The screw’s tightening torque should be 0.3 to 0.5 N･m. Screw securely.Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
