17About the Rack MountThis unit can be installed onto an EIA standard rack.1 Using the 6 included rack mount adapter screws, mountthe included rack mount adapters.2 Loosen the screws, and remove the 4 pedestals.3 Mount onto the rack using screws (commerciallyavailable). Tighten the screws securely.Always ensure that the cables connecting to the connectorson the rear panel are clamped to the pillars of the rack etc.and that the mass of cables does not lie directly on the unit.Setting up the camera recorderSetup the camera recorder to configure a system by connecting this unit with the AG-CA300G and the camera recorder.For the setting of the camera recorder, refer to the operating instructions of the camera recorder.Setting of the video formatUsing camera recorder menu operations or switchoperations, set the video signal format of the output from theSDI output connector of the camera recorder and the videosignal format for recording to the same format.Setting of the GENLOCK MODESet the GENLOCK MODE of the camera recorder toGENLOCK: EXT using the menu operation of the camerarecorder.(However, it is not necessary to set with AG-HPX300/301/302/304 and AG-HPX500/502.)Setting of the GENLOCK PHASESet the GL PHASE of the camera recorder to GL PHASE:HD SDI using the menu operation of the camera recorder.If it is used connected to the AG-HPX500/502, set the GLSELECT item to SDI, and the GL PHASE item to OFF.Also, set the GL PHASE item to “HD SDI”. When this unit isused connected to the AG-HPX500/502, set the GLSELECT item to “SDI”, and the GL PHASE item to “OFF”.Setting of the CRT VFSet the VF TYPE to be used on the camera recorder usingthe menu operation of the camera recorder.If it is set to VF TYPE: SD, only the SD video can bechecked for the return video (RET video) from this unit.Setting of the batteryThe power to the camera recorder from the unit is suppliedto a battery connector on the camera recorder via thecamera adapter. When the power is supplied from the unitconnecting the camera adapter and the camera recorder,set the battery setting on the camera recorder to “TYPE B”,the voltage for full display to “13.0 V”, the near end voltageto “12.5 V” and the end voltage to “12.0 V”. For furtherdetails, refer to the camera recorder operating instructions.12
