Panasonic AG-CPD20P Operating Instructions Manual

Also see for AG-CPD20P: Operating instructions

Contents

Panasonic AG-CPD20P Operating Instructions Manual Manual pdf 11 page image

11On Recording (continued)In the cases shown below, the actual prerecord andpostrecord time may be shorter than the respective setting.If recording is started immediately after systemstartupPrerecord time will be shorter.[REC] button pressed(Recording starts) [STOP] button pressed(Recording stops)Actual recording timePrerecord time Postrecord time(Time)Startup completedIf recording is started during postrecordintervalPost-recording will be terminated and next recordingstarts. There is no pre-recording interval for the secondrecording.[STOP] buttonpressed[REC] button pressed(Post-recording halted andnext recording starts)[STOP] buttonpressed(Recording stops)Actual recording timePrerecord time Postrecord time(Time)Notes:If you press the [REC] button and [STOP] buttonalternately in rapid succession, the system may notseparate the two recording sessions, resulting in a singlevideo file.If the remaining capacity of the SDHC Memory Card islow, the prerecord time or postrecord time may becomeshorter.Pre-recording is interrupted by playback, trial shoot(RecCheck) or administrator setup.Post-recording is interrupted by playback, trial shoot(RecCheck), automatic file restoration or administratorsetup.••••Selecting the video source to recordYou can select and record video input at the [CAMERA][1], [], [], [4], [5], or [6] connector on the rear panel ofthe recorder. Also, when the action set for the detection oftrigger signals(GPI1-16) is “P1REC”, “PREC” or “PREC” and thetrigger signal is enabled, the selected video is recorded. Ifpre-recording is enabled and the video source is switchedby a recording trigger, the prerecord video is taken from thesource selected before switching, and the video is takenfrom the source selected after switching. You can selectwhether the video source is switched by the recording triggeror not, as well as selecting which video is recorded uponswitching.Example: When video input set for “PREC” is switched tothat set for “P1REC”Recording start trigger activation(Time)Recording of signal from theconnector set for “P2REC”Recording of signal from theconnector set for “P1REC”Pre-recording Recording aftertrigger activationNotes:When switching video input, the video or audio may bebriefly disrupted.For best results, minimize the amount of video sourceswitching while recording.••Playback with the remote control panel is not availableat present. Upgrading is scheduled for the future.For playback, it is recommended to use the Front-Endapplication or Back-End Client application.