Panasonic AG-DV1DC E Operating Instructions Manual

10 - English -1 Slide the Battery upward while pushingBATT RELEASE to remove theBattery Pack. (p. 9)2 Insert the DC Cable into the DC INTerminal.3 Connect the other end of the DCCable to the AC Adaptor as shown.4 Plug in the AC Adaptor.• The POWER Lamp on the ACAdaptor lights up.• When not in use, unplug the AC Adaptorfrom the AC outlet.DC Cable(Supplied)DC IN TerminalNote12POWERLampSupplying PowerCaution:• Charge only with specified charger.• Charge the Battery within an ambienttemperature range of 10 °C and 30 °C.• The Battery may be warm after chargingor just after use. This is normal.• Do not use an insufficiently charged orworn out Battery.• If charging is done in extreme low or hightemperatures, Battery charge timeincreases.Safety precautions:• Do not place the Battery near, or disposeof in fire.• Do not directly connect (short circuit) thepositive (+) and negative (–) terminals.• Never attempt to disassemble orreassemble the Battery.To avoid damage to the Battery:• Do not drop or jar the Battery.• Use the Battery with specified modelsonly.• If the Battery is used in extremely hightemperatures, a safety device willautomatically prevent operation.To ensure longer battery life:• While not in use, remove Battery fromthis unit and AC Adaptor and store in acool, dark, dry place. If you leave theBattery in this unit or on the AC Adaptor,the Battery will no longer be rechargeable.• Keep the Battery terminals clean.Battery CareDC Output ConnectorUse AC Adaptor2BATT RELEASE1Connect the AC Adaptor correctly asshown in the figure.• The battery cannot be charged whilesupplying power from the AC Adaptor tothe camera recorder.