Panasonic AG-DV1DC E Operating Instructions Manual

Recording Features- English- 21Recording Features5 Press +/– to select AV JACK , thenpress SET to select IN.6 Press +/– to select AUDIO SEL , andthen press SET to select LINE.7 Press +/– to select AUDIO DUB , andthen press SET to select ON.• This unit will go to Stand By mode,and “A.DUB ” indication appears inthe LCD monitor.• “LINE A IN” (LINE) or “MIC IN” (MIC)will appear in the LCD monitor. (p. 32)8 Press (PAUSE) to start AudioDubbing.Only PAL (Phase Line alternation) recordedtapes can be audio dubbed. The followingscreen appears if the tape was notrecorded in PAL format.9 Press (PAUSE) to stop AudioDubbing.To listen to the desired audio sound, set theAUDIO setting of the PLAYBACK MODEmenu (Menu OSD: p. 29) as follows:• If the microphone used gets too near thespeaker on your TV or on this unit, ahowling noise (feedback) may occur. Inthis case, either move the mic fartheraway or turn the volume down. (p. 14)• If the tape position is in or was started in ablank section, you cannot use the A.DUBfeature.• When a 16 bit recording is dubbed over,the original audio of the recording will beerased.• When a 12 bit recording is dubbed overand played back, and MIX is selected asthe AUDIO, both the original audio andthe dubbed audio are played back.• If you recorded in LP mode, you cannotuse the A.DUB feature.NoteST 1ST 2MIXSet this position to listen to theoriginal sound.Set this position to listen to theaudio dubbed sound.Set this position to listen to boththe original sound and the audiodubbed sound.AUDIO:The following selections areavailable for 12 bit AUDIO dubbedrecordings only (sound recorded in SPmode only).8, 9PAUSE 5, 6, 7+/– (SELECT)5, 6, 7SETWhen using an External Recording SourceAudio OutTo Audio OutA/V Cable (Supplied)A/V INFollow the steps 1~4 on page 20.