- 44 -Perform focus adjustments using the focus ring. If auto focusing is difficult due to the conditions,then use Manual Focus.≥ Switch to Manual Mode. (l 36)1 Set the FOCUS A/M/¶ switch to [M] to enable Manual Focus.≥ It will switch to MF from AF.2 Adjust the focus by rotating the focus ring.≥ The focus value can be set from MF00 (focus distance: approximately 10.0 cm (3.93 q) [When[FOCUS MACRO] (l 94, 154) is set to [ON]]) to MF99 (focus distance: infinity). The larger thefocus value gets, the further the position where focus is achieved.≥ If you move the FOCUS A/M/¶ switch towards [¶], focus will be adjusted to MF95 on the infinityside. (The FOCUS A/M/¶ switch will return to the [M] position.)≥ To return to Auto Focus, set the FOCUS A/M/¶ switch to [A], or set [AF] to [ON] and switch toAuto Mode. (l 36)≥ If you set [FOCUS MACRO] to [ON], when the distance to the subject approaches within 0.8 m(2.6 feet) approx., the unit switches to the macro range and or . (The unit may switch tothe macro range even when the distance to the subject is 0.8 m (2.6 feet) or more depending onthe subject.).≥ Depending on the zoom magnification, this unit may fail to switch to the macro range, or go to anon-displayed focus value.≥ When you perform a zoom operation in the macro range, this unit may go out of focus.≥ When [AF] is set to [ON] and this unit is set to Auto Mode, auto focusing is performed regardlessof the position of FOCUS A/M/¶ switch. (l 36)≥ When a remote control (commercially-available) is connected, even if you move the FOCUS A/M/¶ switch towards [¶], focus cannot be adjusted to MF95. (l 113)≥ The unit of the focus value display differs depending on the [ZOOM/FOCUS] setting. The settingcan also be changed so that the display disappears from the screen. (l 173)[3]: This mainly enhances the correction performance against fast and subtle camera shake thatfalls in the high frequency range while weakening the correction performance against slowcamera shake that falls in the low frequency range. We recommend that you use this settingwhen panning or tilting this unit many times while recording.RecordingFocusA FOCUS A/M/¶ switchB PUSH AUTO buttonC Focus ringPUSH AUTOFOCUSAM
