Panasonic AG-EZ50UP Operating Instructions Manual

Contents

12CGR-D08A/1BVSB0419CGR-D16A/1BCGP-D28A/1BABABABAB1 h.2 h.3 h 15 min.1 h 10 min. (55 min.)2 h 25 min. (2 h.)4 h 15 min. (3 h 35 min.)5 h 20 min.8 h. (6 h 40 min.)CGR-D53A/1KPUSHBATT.EJECT1212134Power Supplyª Using the AC Adaptor1 Slide the Viewfinder backward and then tilt it upward.2 Insert the battery-shaped connector of the DC Cable into theBattery Holder on the Camera/Recorder.3 Connect the DC connector plug to the [DC OUT] Jack on theAC Adaptor.4 Connect the AC Adaptor and AC Cable.~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ª Using the Battery≥Before use, fully charge the battery.1 Attach the Battery to the AC Adaptor and charge it.≥Since the Battery will not be charged when the DC Cable is connectedto the AC Adaptor, disconnect it.≥The [CHARGE] Lamp lights up, and charging starts.≥When the [CHARGE] Lamp goes off, charging is completed.2 Attach the charged Battery to the Camera/Recorder.Disconnecting the Power SourceSet the [OFF/ON/MODE] Switch to [OFF] and, while pressing the[BATT. EJECT] Button 1, slide the Battery or DC Cable upward todisconnect it.≥For other notes, see page 46.~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~Charging Time and Available Recording TimeA Charging TimeB Maximum Continuous Recording Time≥“1 h 20 min.” indicates 1 hour and 20 minutes.≥Battery VSB0419 is supplied.≥The hours shown in the table below are approximate hours. The numericcharacters in parentheses indicate the recording time when the LCDmonitor is used. In actual use, the available recording time may be shorterin some cases.≥The hours shown in the table below are for continuous recording at atemperature of 68xF (20xC) and humidity of 60 %. If the Battery is chargedat a higher or lower temperature, the charging time may become longer.