55Using the CounterCounter displayYou can display a counter that indicates how muchtime has elapsed during shooting or playback.1 Press the COUNTER button.Each time you press the button, the displaychanges as follows. (Page 76)0 : 00. 00 (CAM mode only)Counter valueCLIP 0 : 00 . 00Displayed when CLIP is selected in theREC COUNTER item on the settings menuDISPLAY SETUP screen.Values are automatically reset whenrecording is started, and counter values aredisplayed for each individual clip.TC 12 : 34 : 56 . 01Time code value (Display time code framedigits in 24 frames when 24P is set, and in30 frames when any other format is set.)UB 12 34 56 78User informationNo display:Data is not displayed.Resetting the counterPress the RESET/TC SET button while the counteris displayed.TC preset modeWhen shooting using a multi-camera, you cansynchronously set the initial values of time code.The camera used for synchronization is theMASTER and the camera being synchronized isthe SLAVE.1 Connect the TC PRESET IN/OUT terminals(VIDEO OUT terminals) on the two deviceswith a pin cable, and turn on the power.MASTER settings2 Check that the MASTER camera is set to theCAM mode, and set the EXT TC LINK itemon the setting menu TC/UB SETUP screen toMASTER.OUTPUTTING LTC SIGNAL is displayed onthe screen, and the time code is output fromthe TC PRESET IN/OUT terminal (VIDEO OUTterminal).Select the same REC FORMAT setting forboth the MASTER and SLAVE cameras,and set the TCG item on the TC/UB SETUPscreen to FREE RUN.To cancel the time code output, press theMENU button.SLAVE settings3 Set the EXT TC LINK item on the settingmenu TC/UB SETUP screen to SLAVE.4 Press the COUNTER - RESET/TC SETbutton. TCG values will be reset to the TCvalues inputted from the MASTER.TC LINK OK will be displayed forapproximately 2 seconds when the menuscreen is closed.If the TC values cannot be set correctly, LINKNG will be displayed.If the SLAVE device is set to 24P, please setthe TC MODE item on the MASTER deviceto NDF.To cancel the SLAVE mode, press the MENUbutton.■••■••••The COUNT value is indicated as a four-digitnumber. The COUNT value is incremented eachtime a new clip is captured if clip metadata hasbeen read in and TYPE2 has been selected asthe recording method.The COUNT value can be reset using thefollowing procedure.Press the MENU button, select META DATA→CLIP COUNT RESET→YES, and push theOperation lever to reset the counter value to 1.USO RESTRITO