23 Preparations1 Hold down [POWER] for at least 2 secondsto turn the power on.2 Press [THUMBNAIL/MODE] to display thethumbnail display off screen.3 Press [MENU/MODE CHK].• Basic operations on the setting menus. (Page74)4 At the “TIME ZONE” item on the settingmenu “OTHER FUNCTIONS” screen, changethe time difference from Greenwich MeanTime using and , and press . (Page 82)OTHER FUNCTIONSPUSH MENU TO RETURNPC MODEBEEP SOUNDCLOCK SETTIME ZONEPOWER SAVELANGUAGESYSTEM FREQUSER FILEUSB HOSTOFF- - - -0:00OFFENGLISH59.94Hz- - - -5 Select “YES” at the “CLOCK SET” item onthe setting menu “OTHER FUNCTIONS”screen.OTHER FUNCTIONSPUSH MENU TO RETURNPC MODEBEEP SOUNDCLOCK SETTIME ZONEPOWER SAVELANGUAGESYSTEM FREQUSER FILEUSB HOSTOFF- - - -OFFENGLISH59.94Hz- - - -YES6 Press or to set “YEAR” to “2007”.CLOCK SETPUSH MENU TO RETURNYEARDAYMONTHHOURMINAPR724132007+/ //-SEL: PUSH: PUSHAny year from 2000 to 2030 can be set.7 Press to move the setting item to“MONTH”.CLOCK SETPUSH MENU TO RETURNYEARDAYMONTHHOURMINAPR724132007+/ //-SEL: PUSH: PUSH8 Press or to set “MONTH” to “MAY”.CLOCK SETPUSH MENU TO RETURNYEARDAYMONTHHOURMINMAY724132007+/ //-SEL: PUSH: PUSH9 Use the same method as in steps 4 and 5 toset “DAY”, “HOUR” and “MIN”.• The 24-hour clock system is used by this unit.CLOCK SETPUSH MENU TO RETURNYEARDAYMONTHHOURMINMAY2025172007+/ //-SEL: PUSH: PUSH10 Press [MENU/MODE CHK] 3 times torelease the menu mode.• An error will occur in the time so check thatthe time is correct before shooting.• If the unit is going to be used overseas,do not set the “CLOCK SET” item to thecurrent time but input the time differencefrom GMT using the “TIME ZONE” item.Setting the calendarThe “CLOCK SET” value is recorded on the data content (clips), and it affects the sequence in which thethumbnails are played back. Before recording, be absolutely sure to check the “CLOCK SET” and “TIMEZONE” settings, and set them if necessary. Described below is the procedure for setting the clock to 5:20PM on May 25, 2007.
