49 PlaybackCMPNT/SDI SEL : This is used to set the format of the D connector output and HD/SD-SDI output signals.(When SYSTEMFREQ is set to 59.94Hz)AUTO The signals corresponding to the setting for SYS FORMAT item (Page 76) on theRECORDING SETUP screen are output.1080i 720P signals are cross-converted to 1080i signals, and output.480i 480i format signals are output; 720P/1080i signals are down-converted to 480iand output.(When SYSTEMFREQ is set to 50 Hz)AUTO The signals corresponding to the setting for SYS FORMAT item (Page 76) on theRECORDING SETUP screen are output.1080i 720P signals are cross-converted to 1080i signals, and output.576i 576i format signals are output; 720P/1080i signals are down-converted to 576iand output.SDI OUT ON SDI signals are output.OFF SDI signals are not output.SDI METADATA ON The meta-data is superimposed onto the HD-SDI signals.OFF The meta-data is not superimposed onto the HD-SDI signals.SDI EDH ON EDH is superimposed onto the SD-SDI signals.OFF EDH is not superimposed onto the SD-SDI signals.SETUP This is used to adjust the setup level of the video output signals during playback in the480i format.• This item is not displayed on the menu when SYSTEM FREQ is set to 50 Hz.0% The setup level of the video output signals is set to 0 %.7.5%A The setup level of the video output signals is set to 7.5 %.The setup level for component output (D connector), SDI output and 1394 input recordingis set to 0 %.The HD/SD-SDI output signals comply with the following standards.HD : SMPTE 292M, 296M, 299MSD : SMPTE259M-C/272M-A, ITU-R BT. 656-4The underlined settings are the factory mode settings.
