26P2 cards (continued)Ejecting P2 cards1 Press .When the P2 card access LED to be ejected isblinking in orange, press to stop it blinking.2 Open the card slot cover, push the cardeject button once, and when the buttonpops out, push the button again.3 After ejecting the P2 card, close the cardslot cover.• Do not eject cards or turn off the power in thefollowing situations: otherwise, this may causeP2 card trouble.a While the orange P2 card access LED deviceis changing from blinking to lighting after theP2 card has been insertedb During recording, during the process tocomplete recording or while the P2 cardaccess LED is blinking• In the event that a P2 card being formatted oraccessed has been ejected, “TURN POWEROFF” is displayed on the LCD monitor. In a caselike this, turn the power off and then turn it backon.When a card was ejected while it was beingformatted:Re-format the card.When a card was ejected while its data wasbeing accessed:Something may have gone wrong with one of theclips (Page 30). Check the clips, and repair theabnormal one. (For details on repairing clips →page 36)12• During playback, a P2 card will not be recognizedeven if it has been inserted into the other emptyslot, and the P2 card access LED will notlight. After playback is completed, the P2 cardrecognition process is started.• If the P2 card is ejected while thumbnails aredisplayed, the thumbnail display screen will becleared.Precaution for using P2 cardsP2 cards must always be formatted using a P2device prior to use.Card eject button
