50 Adjusting the White balance and Black BalanceChapter 4 Adjustments and Settings for Recording7 The adjustment will take effect in a fewseconds, and the following messagewill appear:• The adjusted value is automatically stored inthe selected memory (A or B).AWB Ach OK 3.2K8 If the subject’s colour temperature islower than 2300K or higher than 9900Kthe following message appears:• If the arrow points down (↓) the actual colourtemperature is lower than the temperatureindicated. If the arrow points up (↑) the actualtemperature is higher than the temperatureindicated.AWB Ach OK 2.3KWhen you have no time to adjust thewhite balancePosition the WHITE BAL switch at [PRST].When the white balance has not beenautomatically adjustedWhen the white balance has not been successfullyadjusted, the viewfinder displays an error message.If one of the error messages listed below appears,take the appropriate steps, then adjust the whitebalance again.If the error message appears after repeatedreadjustments, the interior of the unit must beinspected. For more information, contact yourdistributor.Error message Description RemediesAWB NGThe colourtemperature istoo high.Select an appropriatefilter.AWB NGThe colourtemperature istoo low.Select an appropriatefilter.LOW LIGHTThere isinsufficientlight.Increase the lightlevel or gain.LEVEL OVER There is toomuch light.Decrease the lightlevel or gain.CHECK FILTERThe FILTERcontrol isdisplaced.Check the FILTERcontrol.Error message Description RemediesTIME OVERAWB was notcompletedwithin the timeallowed.Shooting conditionsmay be unstable.If flicker occurs,press the shutterand readjust theAWB under stableconditions.Viewfinder displays related to whitebalanceSee [Viewfinder Screen Status Displays].
