MenuENGLISHE-106Item Displaymode Description of settings1394 TC REGENP2 TAPE(MCR/VCR)Selects the time code used for recording the signal from equipment connectedto the 1394 terminal.ON:Records using the time code of the signal input through the 1394 terminal.OFF:Records using the time code set in TCG/FIRST REC TC.• If you select ON here, this has priority over the settings in TCG/FIRST RECTC.• If there is no input to the 1394 terminal, the camera follows the settings inTCG/FIRST REC TC.TCGP2 TAPE(Camera)(MCR/VCR)(DUB)Sets the mode in which you advance the time code.FREE RUN:The time code is advanced regardless of the operation mode.Records in the dubbing mode in such a way that the time codes of the clipson the P2 card are carried over. User information is also carried over.• When setting a frame rate other than 25P during operation with the720P/25PN format, the FREE RUN operation for the time code will not beperformed, and the REC RUN operation will be performed instead.REC RUN:The time code is advanced only when recording.FIRST REC TCTAPE(Camera)(VCR)(DUB)Selects the time code to be recorded when you start recording.REGEN:Regenerates the time code on the tape to continue recording.PRESET:The time code on the tape is not regenerated. The value you set in TCPRESET is used as the initial value to record the time code. However, if youperform subsequent shooting, the time code will always be regenerated.TC PRESETP2 TAPE(Camera)(MCR/VCR)(DUB)Sets the initial time code. This is activated when you select PRESET in FIRSTREC TC.indicates the factory setting.RECORDING SETUP screen (continued)
