Panasonic AG-HVX200E Operating Instructions Manual

Also see for AG-HVX200E: Parts list Operating instructions

Contents

ENGLISHReferenceE-120DisplaysSomething is wrong withthe time code display.• The time code display may not register a regular count if a tape isplayed in the reverse slow mode. This is normal.—The remaining tape displaydiffers from the actualamount of tape remaining.• The remaining tape is not displayed accurately if you shootcontinuously for periods of less than 30 seconds.—• The display may show 2 to 3 minutes less than the actual timeremaining on the tape.—PlaybackCannot play even when Ipress the play button.• Make sure the MCR/VCR lamp is on (press the mode button).No kind of playback operation can be performed unless this lamp ison.P 61, 62Cannot play back P2 cardsor tapes.• Make sure the MEDIA switch is in the correct position.If not, set it to the P2 or TAPE position.P 61, 62Mosaic-like noise appearswhen I cue or review a tape.• This noise is inherent to digital video technology. This is normal. —Images do not appear onthe television even thoughI have connected thecamera-recorder properly.• Make sure the input selector on your television is set to video input.Read the television’s instructions carefully and select the correctvideo input connector for the camera-recorder.—• When a component video cable is connected, video signals are notoutput from the VIDEO OUT and S-VIDEO OUT connectors.P 78The playback images arenot displayed clearly.• The camera-recorder’s heads may be dirty.Images will not be displayed clearly if the heads are dirty.—Cannot hear any soundfrom the camera-recorder’sspeaker.• You may have turned down the camera-recorder’s volume controltoo far.Adjust the volume level using the AUDIO MON/ VAR button+.P 74I can hear two sets ofsound.• You may have selected “MIX” as the 32K(12bit) AUDIO setting inthe PLAYBACK FUNCTION screen.P 108• If you perform audio dubbing on a tape that was recorded with 32K(12bit) selected as the AUDIO REC setting in the RECORDINGSETUP screen, you will hear the sound heard during recordingand that of the audio dubbing. You can also listen to each soundseparately.P 105When I performed audiodubbing, the original soundwas erased.• If you perform audio dubbing on a tape that was recorded with 48K(16bit) selected as the AUDIO REC setting in the RECORDINGSETUP screen, you will hear the sound heard during recording andthat of the audio dubbing. To leave the original sound intact, makesure that 32K (12bit) is selected when you shoot.P 105Cannot perform hot swapplayback.• This unit does not support hot swap playback.To replace one card with another during dubbing, stop the dubbingfirst, and upon completing the replacement, resume it.P 86