58 (E)ENGLISHOther settingsSetting methodOne hundred panel statuses can be stored in eventmemories 0 to 99. Press the Set button, set the eventnumber using the number keys, and enter the setting using[Enter].Event memoryEvent00EPress the [Pattern] button, input the pattern number usingthe number keys, and execute using [Enter]. If the patterndoes not exist, operation will jump to the nearest patternnumber.Each time [Pattern] is pressed, the function is set to ON orOFF. The default setting is MIX (56).Pattern numbers are incremented and decremented usingthe “+” and “–” keys. Patterns that do not exist are skippedand displayed in turn.Pattern settingsPattern3015Set button: Its lamp lights during the setting process. When [Enter] is pressed, it flashes for two seconds and thengoes off.When the setting is in progress, Event is displayed in reverse video, and the event is then entered using [Enter]. Eventnumbers can be incremented and decremented using the “+” and “–” keys. Empty events are indicated by [E] appearing nextto the event number.Recall methodPress the [Recall] button, select the event number to be loaded using the number keys, and recall it using the [Enter] or[AutoTake] button.Recall button: Its lamp flashes while recall is underway. It lights when the button is set to ON, and goes off when it is setto OFF or when the recall is completed.Since the input settings are not reflected during loading, events are executed in respect of the input set beforehand.Events 50 to 59, 60 to 69, 70 to 79, 80 to 89 and 90 to 99 can be set consecutively in units of 10 events and also recalledconsecutively so they can also serve as key frame settings. Events are executed using the [AutoTake] button. With therecall of events 50 to 99, the Setup status of the head event is valid.Clearing eventsSet the number of the event to be cleared using [Recall], and execute clearing using [Shift] + [Enter]. Clearing all the eventsis possible by inputting a period twice at the recall stage and then pressing [Shift] + [Enter]. Alternatively, this can beachieved by starting the system by pressing [Shift] + [Enter] when the power is turned on, and restoring the factory settings.