Automatic editing (deck to deck)– 34 –Match frame processing functionWhen using two VTRs for editing, a total of four edit points—namely, the player’s IN and OUTpoints and the recorder’s IN and OUT points—need to be entered. However, since the lastedit point is calculated automatically, only three of these edit points must be entered.Negative duration functionThis function is used by combining setup menu No. 301 (IN/OUT DEL) and No. 302 (NEGAFLASH) described on page 63.Entering the edit points1 Search for the edit IN point by performing the jog or shuttle operation.Establish the still picture mode at the desired position.Refer to page 28 for details on the jog/shuttle operations.2 Press the SET button while holding down the IN button.The edit IN point is now entered.The edit IN point value now appears on the display.3 Search for the edit OUT point by performing the jog or shuttle operation.Establish the still picture mode at the desired position.Refer to page 28 for details on the jog/shuttle operations.4 Press the SET button while holding down the OUT button.The edit OUT point is now entered.The edit OUT point value now appears on the display.1, 32, 4ONOFFLLEVEL CUE VIDEOASSEMBLEDVAUDIO ANALOGVIDEO Y PB PRAES/EBUCMPSTINPUT SELECTCH CONDITIONSCH CFSHIFT ADJ START RESETSTAND BYUB EXT EETC INTTC MODETAPELOCAL REV FWDPULLOPENJOGPUSHEJECTAUTO OFFSHTLSLOWCONTROLREMOTEEDITREWPLAYSERVOSTOPPLAYERRECREC INHIBITFFRECORDERTC/CTLTC SETINSERT-VIDEO CH1 CH2 CUE TCAUTO EDIT PREROLLPREVIEWREVIEWRECPBPULL FOR VARIABLEPULLOPENHEADPHONESCH1 CH2RMONITOR SELECTWTRIMIN SET– +OUTAOUTAINMETERFULL/FINEPOWERUSER SET SDISDISDTI(V&A)