Automatic editing (deck to deck)– 38 –Executing automatic editing1 Press the AUTO EDIT button.Automatic editing is now performed.• To stop the editing at any time, press the STOP button.• When the edit OUT point is reached, the unit goes into the stop mode after postrolling.PostrollWith assemble editing, editing continues for approx. 2 seconds even after the edit OUT pointhas been passed, the tape is rewound to the OUT point, and the unit goes into the stopmode.With insert editing, the unit goes into the play mode after the edit OUT point has beenpassed, the tape is rewound to the OUT point, and the unit goes into the stop mode.Retry functionIf the AUTO EDIT button is pressed again after the STOP button has been pressed to stopthe editing, editing will start again from the beginning.Auto tag editingIf the AUTO EDIT button is pressed when the next edit point has not yet been entered uponcompletion of editing, the previous edit OUT point will be entered as the IN point, and editingis performed accordingly.To release the auto tag mode, press one of the tape transport buttons (PLAY, etc.).The entered points are automatically cleared after editing is executed. However, the previousediting points can be recalled by pressing the TRIM+ (or TRIM–) and SET buttons together.1ONOFFLLEVEL CUE VIDEOASSEMBLEDVAUDIO ANALOGVIDEO Y PB PRAES/EBUCMPSTINPUT SELECTCH CONDITIONSCH CFSHIFT ADJ START RESETSTAND BYUB EXT EETC INTTC MODETAPELOCAL REV FWDPULLOPENJOGPUSHEJECTAUTO OFFSHTLSLOWCONTROLREMOTEEDITREWPLAYSERVOSTOPPLAYERRECREC INHIBITFFRECORDERTC/CTLTC SETINSERT-VIDEO CH1 CH2 CUE TCAUTO EDIT PREROLLPREVIEWREVIEWRECPBPULL FOR VARIABLEPULLOPENHEADPHONESCH1 CH2RMONITOR SELECTWTRIMIN SET– +OUTAOUTAINMETERFULL/FINEPOWERUSER SET SDISDISDTI(V&A)