– 67 –USER menuItemSettingNo.SuperimposedNo.SuperimposedDescriptiondisplaydisplay400STILL00000.5sTIMER00015s000210s000320s000430s000540s000650s00071min00082min401SRC0000STEPPROTECT0001HALF402DRUM0000OFFSTDBY0001ON403STOP0000STEPPROTECT0001HALFThe underline on the setting item denotes the initial setting.In order to protect the tape and VTR helical heads, it is recommended that the Still Timer beset for automatic tape protection mode in 30 seconds or under.This selects the time to be taken until the unit goes into thetape protection mode when it is left standing in the stop orsearch still (JOG/VAR/SHTL) mode. (Unit: s = second, min =minute)With the DV or DVCAM format, the maximum time which canbe set is 10 s even when a setting above 10 s has beenselected. The selection screen, however, will operate for up to2 minutes.This selects the operation during the tape protection modewhen the unit is left standing in the still status during thesearch mode (JOG/VAR/SHTL).0: STEP FWD.1: HALF LOADING.When STEP FWD is selected, the unit automatically goes intothe HALF LOADING mode when the total time for which theunit is left standing in the still status reaches 30 minutes(DVCPRO) or 1 minute (DV or DVCAM).This selects the drum operation in the STANDBY OFF mode.0: The drum stops rotating.1: The drum continues rotating.This selects the operation in the tape protection mode whenthe unit has been left standing in the STOP mode.0: STEP FWD1: HALF LOADINGWhenSTEPFWDisselected,theunitisautomaticallytransferred to the HALF LOADING mode when the total timeduring which it has been left standing in the STOP modereaches 30 minutes (or 1 minute with a DV/DVCAM tape).ItemSettingNo.SuperimposedNo.SuperimposedDescriptiondisplaydisplay500VITC000010LPOS-1000111L000212L000313L000414L000515L000616L000717L000818L000919L001020LThe underline on the setting item denotes the initial setting.This sets the position where the VITC signal is to be inserted.(The same line as for VITC POS-2 in 501 cannot be selected.)
